| MODEL | CLPS150-W1V12 | CLPS150-W1V24 | |||||
| OUTPUT | RATED VOLTAGE | 12V | 24V | ||||
| NO-LOAD VOLTAGE(MAX.) | 12.6V | 25.2V | |||||
| VOLTAGE TOLERANCE | ±5% | ±5% | |||||
| RATED CURRENT | 12.5A | 6.25A | |||||
| CURRENT RANGE | 0-12.5A | 0-6.25A | |||||
| RATED POWER | 150W | 150W | |||||
| RIPPLE& NOISE (MAX.) | 120mVp-p | 150mVp-p | |||||
| POWER FACTOR(Typ.) | 0.6 | 0.6 | |||||
| INPUT | VOLTAGE RANGE | 100-240VAC | |||||
| FREQUENCY RANGE | 50-60 Hz | ||||||
| AC CURRENT(Typ.) | 2.56A/115V, 1.28A/230V | ||||||
| EFFICIENCY(Typ.) | 90% | 90% | |||||
| COLD START CURRENT | 30A/AC220V | ||||||
| SETUP, RISE, HOLD UP TIME | 200ms, 100ms, 30ms | ||||||
| NO-LOAD CURRENT | <50mA/240VAC | ||||||
| PROTECTION | OVER LOAD | hiccup 115%~135% of the rated power 150W, | |||||
| recovers automatically after fault condition is removed | |||||||
| OVER CURRENT | protected over the maximum rated current, | ||||||
| recovers automatically after fault condition is removed | |||||||
| SHORT CIRCUIT | hiccup short circuit, | ||||||
| recovers automatically after fault condition is removed | |||||||
| OVER TEMP | protected when the Rectifier ≥105°C, | ||||||
| recovers automatically after temperature fall to environment temp | |||||||
| ENVIRONMENT | WORKING TEMP&HUMIDITY | –20°C~+60°C (no frost), 20%~90%RH | |||||
| STORAGE TEMP&HUMIDITY | –40°C~85°C, 10%~95%RH | ||||||
| SEISMIC CAPACITY | 10-500Hz 2G 10.min/1 60min | ||||||
| WITHSTAND VOLTAGE | I/P-O/P: 1.5KVAC/1min, I/P-F/G: 1.5KVAC/1min, O/P-F/G: 0.5KVAC/1min, | ||||||
| INSULATION RESISTANCE | 100M ohm s/DC500V | ||||||
| SAFETY&EMC | SAFETY STANDARDS | GB4943 ;IEC60950-1; EN60950-1 | |||||
| EMC STANDARDS | EN55022 CLASS A;GB9254 | ||||||
| REMARK | 1. The above mentioned data were measured at 220VAC input and 25°C. | ||||||
| 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated | |||||||
| with a 0.1uf & 47uf parallel capacitor. | |||||||
